beautypg.com

Advanced operations – Numark Industries CDN-88 User Manual

Page 9

background image

CDN-88 Dual CD Player

- The Leader in DJ Technology

©2000 Numark Industries

- 9 -

http://www.numark.com

Advanced Operations

LOOPING:

A loop is any area of a CD that you choose to repeat with no breaks. On the

CDN-88 two seamless loops are possible. There are 3 buttons associated with the loop
feature.

LOOP IN:

The “LOOP IN” is where you wish for the loop to actually start. The initial “CUE” point of the CD is also the default “LOOP IN” point for both loops

or “Hot Start” point. If you wish to set a new “LOOP IN” point, just

while the CD is playing when it reaches the desired point. The “LOOP

IN” LED will light indicating a new loop is set. The “Hot Start” LED will also illuminate indicating a point has been set and is accessible. By default
the “LOOP IN” also becomes the “STUTTER” or “Hot Start” point.

or

NOTE: The CD Player will always remember a new set point as the “LOOP IN” or “Hot Start” point until you actually set
a new “LOOP IN” point or put in a new CD. The new point will be accessible until you remove the CD from the unit. If

you change tracks and you previously set a “Loop In” on another track, pressing

will jump to that point.

LOOP OUT:

The “LOOP OUT” determines the end point for a loop. The first time you press

while a CD is in play mode, the “LOOP OUT” LED will turn

on and flash while the song automatically returns to the “LOOP IN” point with no breaks and continues to play. When the song reaches the “LOOP

OUT” point again it returns to the “LOOP IN” point and continues to repeat this action. You will notice the “LOOP IN” LED will also be flashing

during loop action. To release or end the LOOP press

a second time and play will continue forward when the song passes the previously

set “LOOP OUT” point. The “LOOP OUT” LED will be lit solid indicating that the “LOOP” is now in memory for “RELOOP” purposes.

Note: The “LOOP OUT” point will be erased if “LOOP IN” is pressed or a new “CUE” point is set after the “LOOP OUT” point. This is
important because without this point “RELOOP” will not be possible.