Additional information, Changing the digital security code, Find handset – NEC DTR-IR-2 User Manual
Page 29: Installing the beltclip, Headset installation, Hanging, Igital, Ecurity, Andset, Nstalling
B a s i c s
[ 2 5 ]
A
DDITI
ON
AL
INFO
RM
A
T
IO
N
Additional Information
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and the base unit.
Normally, setting the code is not necessary. In the rare situation that you suspect another
cordless telephone is using the same security code, you can change the code. To change the
digital security code:
1
De-register the handset (see “Deregister the handset“ on
).
2
Register the handset by following step 2-3 in “Registering the handset“ on
Find Handset
To locate the handset, press
find handset
on the base when the phone is in standby mode. All
registered handsets beep for 60 seconds, and
Pa gi n g
appears on the handset display. To cancel
paging, press any key on the handset or
find handset
on the base..
Installing the Beltclip
To Attach the Beltclip
Insert the beltclip into the holes on each side of the handset. Press down
until it clicks
To Remove the Beltclip
Pull either side of the beltclip to release the tabs from the holes.
Headset Installation
Your phone can be used with an optional headset. To use this feature,
insert the headset plug into the headset jack. Your phone is ready for
hands-free conversations. (Headset can be purchased by calling your local
NEC Representative.)
If the battery pack is completely drained, the handset will not beep when paging.
note