H system troubles – Napco Security Technologies NAPCO EXPRESS XP-600 User Manual
Page 13

13
H System Troubles
Keypad Beeps or
H
SYSTEM Flashes
Zone light
ON
System Trouble
Condition
Action
2 Beeps
2
Fire Trouble
A problem has been detected in the Fire Circuit.
Call installing company for service.
2 Beeps
3
Wireless
Receiver Trouble
A problem has been detected with the wireless receiver.
Call installing company for service.
2 Beeps
4
Wireless
Receiver Jam
A problem has been detected with a wireless receiver.
Call installing company for service.
3 Beeps
1-6
Wireless
Transmitter Low
Battery
The battery in a wireless transmitter is low and should be replaced. This transmit-
ter is on the zone corresponding to the number of the lit zone light. The replace-
ment battery for the GEM-Trans2 door/window transmitter, GEM-PIR motion de-
tector and GEM-GB glass break detector is the Duracell DL123A. (2 required for
the GEM-PIR and GEM-GB.) The GEM-DT Dual Technology Sensor requires C-
Cell Duracell MN1400 batteries (4). Warning: Replace batteries only with the
same type as specified above. Use of another battery may present a risk of fire or
explosion. Do not recharge or disassemble battery, or dispose of in fire.
4 Beeps
1-6
Wireless
Transmitter
Supervisory
Failure
A problem has been detected with a wireless transmitter.
Call installing company for service
5 Beeps
1-4
Wireless Smoke
Detector
Low Battery
The battery in a wireless smoke detector is low and should be replaced. This
wireless smoke detector should be marked with a number corresponding to the
number of the lit zone light. The replacement batteries required are Duracell 9
Volt Alkaline (2).
Warning: Replace batteries only with the same type as specified above. Use of
another battery may present a risk of fire or explosion. Do not recharge or disas-
semble battery, or dispose of in fire.
6 Beeps
1-4
Wireless Smoke
Detector Supervi-
sory Failure
A problem has been detected with a wireless smoke detector.
Call installing company for service.
7 Beeps
1-6
Zone Trouble
Call installing company for service.