Newcon Optik NEWCON LRB 3000 PRO - Manual (Page 11)

• Cd12 – this mode sets the target selection to First. No
other parameters of those, which were previously set, are
influenced.
• Cd13 – this mode sets the target selection to Auto. No
other parameters of those, which were previously set, are
influenced.
• Cd14 KMH – the unit will measure and display two
parameters at once as distance in meters and speed in
kilometers per hour. The target selection and the reticle
shape inherit the previous value.
• Cd15 MPH – the unit will measure and display two
parameters at once as distance in yards and speed in
miles per hour. The target selection and the reticle shape
inherit the previous value.
• Cd16 – this is the self-test mode. All segments on
display will blink during 8 seconds. None of the
parameters, which were set before, will change.
• Cd17 – this is the self-test mode, performing compass
calibration. None of the parameters, which were set
before, will change.
18
If you choose more than one parameter to measure (for
instance, distance and azimuth), the measured results will appear
on the display every half second.
If the A button is held (pressed) the System automatically
enters SCANNING mode. At this mode, the System repetitively
performs distance measuring and displaying. The time interval
between measurements is approximately 0.25 second.
The
maximum measuring distance range for most objects will be
about 3000 meters. The maximum measured distance varies
greatly depending on the reflectivity of the target, weather
conditions and more.
Target reflectivity depends on its color, surface finish, shape
etc. Bright colors are more reflective than darks. A polished
surface is more reflective than a rough one. Larger targets are
easier for distance measuring. Measuring a target faced at 90
o
(perpendicular to the laser beams path) provides optimal results.
Bad weather conditions (rain, fog, snow, mist) will reduce the
maximum measured range. Bright sunny days will reduce
performance as well. While the unit will work through many
glass types, measuring through glass will affect the results. Hand
tremor also influences the results. Use tripod to measure distance
to far-away objects.
The unit can estimate distance to up to 7 targets
simultaneously. The mode selection logic allows choosing the
nearest (‘first’), the farthest (‘last’) or the most reflective (‘auto’)
target. This mechanism helps to choose a correct target
11