Nikon WIRELESS KEYPAD KIT HMSC7075 - Manual (Page 6)

6
Troubleshooting
Problem Solution
Module will not register
with the Wireless System
Controller • Ensure that the module's AC adapter is plugged in or has fresh batteries.
• Ensure that the Wireless System Controller is powered and online.
• Ensure that you are pressing the Discovery button.
• Reposition the module closer to the Wireless System Controller.
• Try another location.
The Wireless System
Controller does not
recognize the module
during discovery mode Make sure your Wireless System Controller indicates discovery mode and that the
module is powered with fresh batteries. Press the Discovery button found inside of the
battery compartment. If this continues to fail, you will need to try another location for
the module. You may also try a hard reset by holding down the Discovery button while
powering on the module. After resetting the module, please try to discover it again.
The status LED turns red
when I touch the key to
the Keypad port. The key was not accepted by the system. Try registering the key again.
Features and Specifications
• Device signal communication
• LED in module illuminates when activity occurs
• Home and Away LEDs light when either is activated
• Weather
resistant
• Hardware and base provided for either wall or table mounting
• AC power adapter included
Communication frequency: 418 MHz
Typical range outdoors: 200 feet (60 m)
Typical range indoors: 60 feet (18 m)
Dimensions: 3.94"L × 2.32"W × 1.10"H (100mm × 59mm × 28mm)
Operational temperature/ humidity: 32° to 104° F with 10% to 80% humidity with all components operating within
manufacturer thermal limits
Storage temperature: -25° C to 75° C