Powercom 625A - Manual (Page 15)

10. Troubleshooting
__________________________________________________________
____
PROBLEM POSSIBLE CAUSE ACTION TO TAKE
On/off/test/silence
button not pushed or
push too short Press the on/off/test/silence
button more than 1 second
Battery voltage less than
10V Recharge the ups at least 4 hours
PCB failure Replace the PCB, call for service
UPS not on
LED not light
Load less than 20W at
battery mode Normal condition
Power cord lose Replug the power cord
AC FUSE burn out Replace the AC fuse
Line voltage too high, too
low or black out Normal condition
UPS always at
battery mode
PCB failure Replace PCB, call for service
battery not fully charged Recharge the UPS at least 4 hours Back up time
too short
PCB failure Replace PCB, call for service
Buzzer
continuous
beeping Overload Remove the noncritical loads
RED LED light Battery failure Replace battery, call for service