Pentair Light and Return Water Flow Quasar - Manual (Page 10)

P/N 98748000 10 REV. F 1-6-05
8. Thread the bulb assembly nut until it just touches the fitting body, then finger tighten.
CAUTION
Do not over tighten as adjustability of flow director may be impaired and/or damage to parts causing
leakage may occur. If low director does not rotate by hand, nut is too tight.
9. Take the red cap/plug off and gently bring the wire connectors through the back side of the bulb
assembly. Save red cap/plug for storage and winterizing.
10. Connect the wire connectors from the bulb assembly to the wire connectors attached to the snap-on
cord cap.
NOTE
There is no polarity (no positive or negative) to the wires, either connection will work.
11. Snap cap onto end of body and turn so that the electrical cord is pointing down; see Figure 12.
WARNING
Risk of electric shock. Connect only to a circuit protected by a GFCI. Failure to do so can
result in death and/or serious injury.
12. Reconnect the power to a circuit in accordance with the appropriate electrical connections. See
Sections III and IV, Electrical Connections. If the light is not on, press the switch on the
transformer case once.
WARNING
This is an electrical appliance. Unsupervised use of this product by children can result in
injury and/or death.
SECTION VI. STORAGE AND WINTERIZING INSTRUCTIONS
1. It is common practice to drain the water level to a point below the skimmer and the light, for
winterizing.
2. For storable pools: remove power from the unit by taking the power cords’ three-prong plug and
disconnecting it from its electrical outlet.
For permanent pools: turn off all electrical power supplying the light circuit at the main circuit
breaker.
3. Remove the snap-on cord cap by inserting a slotted screwdriver into the access hole and prying
upwards, as illustrated in Figure 20 in the relamping instructions.
4. The wire connectors should be gently disconnected and pushed into the rear of the bulb assembly.
5. Push red cap/plug into rear of bulb assembly to seal it.
6. Remove the bulb assembly nut.