Philips 21PV358 - Manual (Page 6)

EN
Preparing the remote control for
operation
The remote control and its batteries are packed
separately in the original TV-Video Combi pack-
aging. You must install the batteries in the
remote control before use.
1. 1. Take the remote control and the enclosed
batteries (2 batteries).
2. 2. Open the remote control's battery compartment
and place the batteries in it as shown in the pic-
ture and close the battery compartment.
The remote control is now ready to use.
Its range is approximately 7 metres.
Connecting the cable
1. 1. Insert the aerial cable plug into the AERIAL
at the back of the TV-Video Combi.
2. 2. Connect the mains cable to the wall socket.
3. 3. If the little red standby light (STANDBY ) at
the front panel of the set is not lit, please
switch on the set using the main power
switch. The power switch
is located on the
left side panel of the set.
4. 4. Language setting picture will appear on the
screen.
You can find more details in chapter 'Preparation
for use'.
Connecting additional devices
You can connect additional devices such as
decoders, satellite receivers, camcorders, etc. to
the EXT1 socket.
Navigation in the screen menu
You can check/change many functions and set-
tings of your TV-Video Combi via on-screen
menu. The individual functions are selected, via
the remote control as follows:
Call up the menu: with .
To select: with .
To enter or change your selection: with the
number buttons
or with
To save or confirm: with .
To cancel: with .
To end: with .
STATUS/EXIT
CLEAR
FWD 1 - B
STOP C - L PLAY B - K 0..9
STOP C - L PLAY B - K
MENU
1. Connecting the TV-Video Combi
I do not see a Language setting picture
* Check the cable connections.
The respective scart socket is usually marked
'AV' or 'TV' on the decoder or satellite receiver.
2. Important notes for operation
Switching on
You can switch on the TV-Video Combi with
.
If you press , , ,
, , or while
the set is in Stand-by, the power will be auto-
matically turned on.
Note that the keys
will be inactive for
about 5 seconds just after having switched the
TV-Video combi off.
Power outage/no power
Channel information remains saved for up to 10
year, the time and timer information is saved for
up to 1 minute.
0..9
0..9 REW 0 - s FWD 1 - B PROG P–
PROG P+ STOP C - L PLAY B - K
STANDBY/ON y y
SELECT K L CHOOSE B
→ TIMER
PICTURE CONTROL
RECORD SET UP
VCR SET UP
TUNER SET UP
GENERAL SET UP
END=EXIT
[14 inch]
[14 inch]
4
PUSH MENU TO CONTINUE
T6400EZ-BG/DK(EN).qx3 03.4.21 15:51 Page 4