Panasonic MC-UG585 - Manual (Page 38)

- 11 -
V Vo olltta ajje e P Prro otte ec ctto orr tte errm ma all E Ex xtte en ns siió ón n d de e c co orrd dó ón n H He errrra am miie en ntta as s
120 V c.a. (60Hz) Si 9,1 m (30 pi) Opcional
Power Thermal Protector Cord Length Tools
120V AC (60Hz) Yes 9.1 m (30 Ft.) Optional
Alimentation Protecteur thermique Longueur du cordon Accessoires
120 V c.a. (60Hz) Oui 9,1 m (30 pi) Optionnels
FEATURE CHART
D Diia ag grra am ma a d de e c ca arra ac ctte erríís sttiic ca as s
Tableau des caractéristiques
- 38 -
BEFORE REQUESTING SERVICE
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Vacuum Cleaner 1. Unplugged at wall outlet. 1. Plug in firmly. Push ON-OFF
will not run. switch to On.
2. ON-OFF switch not turned on. 2. Push ON-OFF switch to ON.
3. Tripped circuit breaker/blown 3. Reset circuit breaker or replace
fuse at household service panel. fuse.
Poor job of dirt 1. Full or clogged dust bag. 1. Change bag.
pickup.
2. Broken belt. 2. Replace belt.
3. Clogged hose or nozzle. 3. Clean hose or nozzle area.
4. Hose not inserted fully. 4. Insert hose.
5. Worn agitator. 5. Replace agitator.
6. Hole in hose. 6. Replace hose.
7. Dust cover improperly installed. 7. Properly install dust cover.
Dust escapes 1. Bag improperly installed. 1. Properly install bag.
the paper bag.
2. Bag torn. 2. Replace bag.
WARNING
Electrical Shock or Personal Injury Hazard
Disconnect the electrical supply before servicing or cleaning the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury from vacuum
cleaner suddenly starting.