PYLE Audio PLTDF25 - Manual (Page 9)

User ’s Manual - page 8
Preparing and Using The Remote
Control
* Before using the remote control,
please take the transparent insulator
strip off the bottom of remote control.
-Do not subject the remote control to
excessive shock.
-Do not put in a pocket.
-Keep away from food, moisture and
dirt.
-Do not place in direct sunshine.
* Point the remote control at the remote
sensor (11) from no more than 6 feet
away.
* If the IR sensor is exposed to direct
sunlight, the remote control may not be
able to communicate with it properly.
You may need to relocate or shield the
IR sensor.
* If you are more than 30 away from
being directly in front of the IR sensor,
the remote control may be unable to
communicate properly.
* The remote control is small,
lightweight precision device. To avoid
damage, short battery life, operational
erros and poor response, observe the
following:
0
USING THE REMOTE CONTROL
Battery replacement
The remote control uses a lithium button
type battery, model CR 2025 3V. Do not
use any other kind of battery in the
remote. Follow these instructions when
installing or replace the battery.
1. Remove the battery holder by
pressing the locking tab with your thumb
A
B
3. Closing the cover
Gently push in the holder until securely
locked into place.
2. Replacing the battery
Replace the battery with the same type
and the (+) side facing up.