Philips PET738 User Manual
Page 14
* Rechargeable batteries have a limited number of charge cycles
and may eventually need to be replaced. Battery life and number of
charge cycles vary by use and settings.
4.2 Powering your remote control
1 Open the battery compartment. Remove the protec-
tive plastic tab (first time users only).
2 Insert 1 x lithium 3V battery, type CR2025, then
close the compartment.
CAUTION
• Batteries contain chemical substances, so they should be dis-
posed of properly.
• Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type.
• Incorrect use of batteries can cause electrolyte leakage and will
corrode the compartment or cause the batteries to burst.
• Remove the batteries if the set is not to be used for a long
time.
• Perchlorate Material – special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
5 Start up
5.1 Setup
1 Press SETUP. A list of features is shown.
PET738_93_CCR 2008.3.26 11:03 Page 14