beautypg.com

Startup overview – P3 International Mold Alert P0270 User Manual

Page 3

background image

stArtuP

overview

If the air is at a relative humidity of 40%, then the dew-point

temperature is only 43°F. The walls and ceilings would therefore have

to be significantly colder for the air to reach its dew-point and for water

droplets to form.

How to achieve the correct temperature and air humidity:

Tips for active heating and ventilation:

Check the dew-point! Surfaces of walls should not fall below a

temperature of 59°F.

Avoid shutting off the heat completely when leaving the house for

extended periods of time.

Ventilate in all weather conditions, even if it’s raining.

Open the windows for a short time to air the room. A partially

opened window does not have the desired effect, wastes heating

energy and can even promote the formation of mold.

If the room air is too dry, particularly in the winter, then electrical

air humidifiers are recommended, since airing at low temperatures

will tend to decrease the humidity further.

When airing a room, a few minutes should be sufficient. Check

the value indicated on your Mold Alert thermo-hygrometer.

1. Select °F/°C and place the audio alarm switch on the back of the

unit in “on” mode.

2. Slide off front compartment and install 2 batteries 1.5V AA. Once

these are in place, the frowning face on the display will light up

briefly and the alarm will sound for 2 seconds.

3. Replace battery compartment cover.

4. Remove the protection film on the display.

5. The unit is now ready to use.