beautypg.com

4 function switches – Pioneer LASERDISC/COMPACT DISC PLAYERS CLD-V2400 User Manual

Page 34

background image

2.4 Function Switches

The CLD-V2600 videodisc player has four physical dip-switches, #1-4, on the rear
panel of the player and the CLD-V2400 has two, #1 & 2. (See diagram below.)
These are used to set several function parameters after the power is turned on.
All switches are UP (OFF) when the players are shipped from the factory. The
factory defaults are as follows: Switch 1: Power On/Load Start is OFF; Switch 2:
BAUD rate is 4800; Switch 3: SQUELCH is BLUE; Switch 4: Not Used.

Sw.1:

With this switch ON, playback begins automatically when the disc table is

inserted or when the power is turned ON with the disc previously loaded. This
switch is set to OFF/UP at the factory.

Sw.2:

The serial communication speed (BAUD rate) can be set to either 1200 or

4800. With this switch ON the speed is 1200 BAUD and with the switch OFF, the
speed is 4800. The factory set value is 4800 BAUD (OFF/UP).

Sw.3:

The background color or “squelch” on the monitor can be set to BLUE or

BLACK. This switch is set OFF/UP at the factory, providing a BLUE Squelch.

Sw.4

Not used.

NOTE: These settings can be modified by entering data into Register C from a
computer via the RS-232C port. (See Section 4.7.6 Register Control Commands,
Register C Set, page 4-43.) Settings for Switch 1, Load Start, Power-On Start
and Switch 2, BAUD Rate, and Switch 3 Background Color can be modified in
Register C.

CLD-V2600 / 2400 Level I & III • Chapter Two

CLD-V2600 / 2400 Level I & III User’s Manual

TP 117

v. 2.0 • 12/93

2-13

Player

Switch #

Function

On (Down)

Off (Up)

Factory Setting

2600 & 2400

Sw 1

Load Start
Power-On Start

Auto

Off

Off

2600 & 2400

Sw 2

BAUD Rate

1200

4800

4800

CLD-V2600 only

Sw 3

Background Color

Black

Blue

Blue

CLD-V2600 only

Sw 4

Not Used

Figure 2-P

4

3

2

1

Function Switch Settings

Switches 1 & 2 are available on both the CLD-V2600
and the CLD-V2400. Switches 3 and 4 are only
available on the CLD-V2600. To initialize the player
with new settings, power down and then power on
the player again.

This manual is related to the following products: