Philips 15MF/20MF - Manual (Page 8)

A
NTENNA
C
ONNECTION
If your antenna has a round cable
(75 ohm) on the end, then you’re ready to
connect it to the LCD TV. If your
antenna has flat, twin-lead wire (300 ohm), you
first need to attach the
antenna wires to the screws on a 300- to
75-ohm adapter(not supplied).
Connect the antenna (or adapter) to one end
of the supplied L-Adapter as shown, and con-
nect the other end of the
L-Adapter to the TV jack on the side of
the LCD TV.
Connect the Cable TV signal to one end of the
supplied L-Adapter as shown, and connect the
other end of the adapter to the TV jack on the
LCD TV.
1
B
ASIC
C
ABLE
TV C
ONNECTION
2
1
�
Antenna
with 75 �
cable
Rear Jack panel of
Television
Outdoor or Indoor Antenna
(Combination VHF/UHF)
OR
�
Twin-lead
wire to
300-75 �
adapter
�
The Cable TV signal from
Cable Company
(75 coaxial cable)
Rear Jack panel of
Television
�
L-Adapter
L-Adapter
A
combination antenna receives normal
broadcast channels (VHF 2–13 and UHF 14–69). Your
connection is easy because there is only one 75 (ohm) an-
tenna jack on the back of your TV, and that’s where the
antenna goes.
Y
our Cable TV signal into your home may be a
single, 75•(ohm) cable. If so, this connection is very
simple. Follow the step below to connect your Cable TV
signal to your new LCD TV.
8