PVI Industries FIREPOWER B40 - Manual (Page 2)

PV500-22A 08-98 2 Section 22A
PVI FIREPOWER

B40 OIL BURNER
ELECTRICAL
1. Wiring to the unit should conform to the
National Electrical Code or the code legally
authorized to your locality. A fused disconnect
switch should be used for water heater
control. Service wiring connections of 115V, 1
phase, 60 Hz. are located in the enclosure on
the water heater. (See Figure 22-10, pg. 14.)
NOTE: Use only copper wire of proper sizing
for incoming service. Damage resulting from
use of aluminum wiring will be excluded from
coverage under the warranty of this unit.
FOR YOUR SAFETY
DO NOT store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
FOR YOUR SAFETY
WARNING: Improper installation,
adjustment, alteration, service or
maintenance can cause injury or
property damage. Refer to this manual
for assistance, or consult a qualified
service agency.