Peavey Bandit 112 - Manual (Page 5)

LINE CORD-120 V products only (22) A
For your safety, we have incorporated a three-wire line (mains) cable with proper grounding
facilities. It is not advisable to remove the ground pin under any circumstances. If it is neces-
sary to use the equipment without proper grounding facilities, suitable grounding adaptors
should be used. Less noise and greatly reduced shock hazard exists when the unit is oper-
ated with properly grounded receptacles.
EXTERNAL SPEAKER JACK (23)
A
Provided for connection of external speaker cabinet. Minimum external speaker impedance
is 8 ohms (4 ohm total impedance).
REMOTE SWITCH JACK (24)
Provided for the connection of the supplied remote footswitch. The footswitch is used to select the Lead or
Normal channels and defeat effects loop. When using remote footswitch, always insert the plug fully (second
click) to insure proper operation.
POWER AMP INPUT (25)
Used to connect line level signal to the power amplifier.
PREAMP OUT (26)
The preamp out can be used to route the amplified signal to a mixing console, tape recorder, etc. Connect
the preamp output using a shielded cable to an input of the tape recorder, mixer, etc. This patch does not
affect the operation of the amplifier.