Panduit PTR2E - Manual (Page 4)

FCC - DECLARATION OF CONFORMITY:
The PTR2E conforms to the following specification:
FCC Part 15, Subpart B, Section 15.107(a) and Section 15.109(a) Class B digital device
Supplemental Information:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following Two Con-
ditions: (1) This device may not cause harmful interference , and (2) this device must accept any
interference received, including interference that may cause undesired operation.
INDUSTRY CANADA NOTICE:
This device complies with Industry Canada ICS-003 class B requirements.
Cet equipement est conforme a l’ICS-003 classe B de la norm Industrielle Canadian
SHOCK HAZARD WARNING:
The printer and power supply should never be operated in a
location where either one can get wet. Personal injury could
result.
MEDIA WARNING:
Always use high quality Panduit approved labels and transfer
ribbons. If adhesive backed labels are used that DO NOT lay flat
on the backing liner, the exposed edges may stick to the label
guides and rollers inside the printer, causing the label to peel
off from the liner and jam the printer. Panduit approved
supplies can be ordered from your local Panduit distributor.
For the name of a dealer in your area, call Panduit Customer
Service at 888-506-5400.
RELOADING HINT:
If you should run out of labels while printing, DO NOT turn the
power switch OFF (0) while reloading or data loss may result.
The printer will automatically resume printing when a new label
roll is loaded.
iv
PTR2E-MAN Rev.A