Philips 6FF3FPB User Manual
Philips Digital Photo Frame

PhotoFrame Firmware Upgrade Instructions
Applicable models 6FF3FPB, 6FF3FPW
Firmware version
056
Release date
October 20, 2008
Release notes
- Preloaded baby photo is deletable
!
Important notice before updating
The firmware upgrade process will remove all photos currently stored on PhotoFrame.
Please make sure all photos on PhotoFrame are properly backed up before updating.
!
Please follow the steps below to upgrade the PhotoFrame firmware.
1
Format SD (Secure Digital) card
2
Copy all files from the ‘
Firmware
’ folder into the root folder of the SD card
(The root folder is the ‘highest’ folder in hierarchy, for example
F:\
)
3
Make sure PhotoFrame is powered Off
4
Insert SD into PhotoFrame with the new firmware into the PhotoFrame
5
Hold the Menu and Power button for 5 seconds to power on the PhotoFrame
6
The firmware upgrade will start automatically, “
upgrade burning
” shows.
!
Warning: Upgrade takes about 2 minutes.
During the upgrade do not disconnect power, remove the memory or make new
connections. Otherwise this may harm your PhotoFrame.
!
7
When firmware upgrade is complete, PhotoFrame will automatically reboot.
8
Remove the memory from the PhotoFrame
9
The upgrade has completed
You can check the new firmware version via
Setup
→
Status
→
Firmware
.