Pride Mobility scooter User Manual

Page 30

www.pridemobility.com

Victory/Rev L/Mar03

WARNING! Lifting weight beyond your

physical capability may result in personal

injury. Ask for assistance when necessary

while disassembling or assembling your

scooter.

assemble or assemble your scooter on a level, dry surface with sufficient room for you to work and move around

your scooter. Keep in mind that the disassembled sections of the scooter will take up more floor space than the

assembled scooter.

I X . D I S A S S E M B L Y A N D A S S E M B L Y

UNPLUG HERE

Figure 16. Battery Harnesses

UNPLUG HERE

Figure 17. Front-To-Rear Connector

DISASSEMBLY

1. Remove the key from the key switch. See V. Your Victory.

2. Push down on the manual freewheel lever. See V. Your Vic-

tory. Putting your scooter in drive mode may make it easier

for you to maneuver the rear section because the drive wheels

are stabilized.

3. Make certain that the seat is locked into position. See VIII.

Comfort Adjustments. Lift the seat up and off of your scooter.

4. Gently lift the rear shroud off of your scooter. The rear shroud

is held in place with a reusable fastener.

5. Unplug both battery harnesses. See figure 16.

6. Loosen the battery straps, then lift both batteries from the

battery wells.

7. Unplug the large, white, 9-pin front-to-rear connector that

attaches the front control console assembly harness to the

electronic controller module harness. See figure 17.

CAUTION! Failing to unplug both battery

harnesses and the front-to-rear connector

prior to further disassembly could result

in permanent damage to your scooter.

Toggle Latch Release
1. Push in the toggle latch release button while pulling back the toggle latch. See figure 18.

2. Position the toggle latch buckle over the top of the toggle latch. See figure 19.

3. Lower the tiller to the scooter floorboard and fully tighten the tiller adjustment lever.