Pride Mobility scooter - Manual (Page 24)

24 www.pridemobility.com Victory/Rev L/Mar03
V I . B A T T E R I E S A N D C H A R G I N G
What type and size of battery should I use?
We recommend deep-cycle batteries that are sealed and maintenance free. Both AGM and Gel-Cell are deep-cycle
batteries that are similar in performance. Do not use wet-cell batteries, which have removable caps.
NOTE: Sealed batteries are not serviceable. Do not remove the caps.
Use these specifications to reorder deep-cycle batteries:
Type: Deep-cycle (AGM or Gel-Cell)
Size: U-1
Voltage: 12-volts each
Amperage: 32 AH (amp hours)
To change a battery in your scooter:
1. Remove the seat and rear shroud. See IX. “Disassembly and Assembly.”
2. Disconnect the battery tie-down strap.
3. Disconnect the battery harness.
4. Disconnect the battery cables from the battery terminals.
5. Remove the old battery.
6. Place a new battery in the battery well.
7. Connect the red battery cable to the positive (+) battery terminal.
8. Connect the black battery cable to the negative (-) battery terminal.
9. Reconnect the battery harness.
10.Reconnect the battery tie-down strap.
11.Reinstall the rear shroud and seat.
Why do my new batteries seem weak?
Deep-cycle batteries employ a different chemical technology than that used in car batteries, nickel-cadmium bat-
teries (nicads), and other common battery types. Deep-cycle batteries are specifically designed to provide power,
drain down their charge, and then accept a relatively quick recharge.
We work closely with our battery manufacturer to provide batteries that best suit your scooter’s specific electrical
demands. Fresh batteries arrive daily at Pride and are shipped fully charged to our customers. During shipping, the
batteries may encounter temperature extremes that can influence their initial performance. Heat diminishes the
charge on the battery; cold slows the available power and extends the time needed to recharge the battery.
It may take a few days for the temperature of your scooter’s batteries to stabilize and adjust to their new room or
ambient temperature.
More importantly, it takes a few charging cycles (partial draining followed by full recharging) to establish the critical
chemical balance that is essential to a deep-cycle battery’s peak performance and long life.
WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds.
Wash hands after handling.
WARNING! Corrosive chemicals contained in batteries. Use only AGM or Gel-Cell batteries
to reduce the risk of leakage or explosive conditions.