Pioneer PWM-T210 - Manual (Page 5)

PWM-T210
Installation Instructions Page 5
Locating the Center of the Display
CAUTION: Proper installation procedure by qualified personnel as outlined in the installation
instructions must be adhered to. Failure to do so could result in serious personal injury and
possible damage to the flat panel.
WARNING: INVERT THE FLAT PANEL PLACE IT ON A SOFT, FLAT SURFACE TO PREVENT
DAMAGE TO THE FLAT PANEL. USE A BLANKET, FOAM, ETC. FAILURE TO DO SO
WILL RESULT IN DAMAGING THE FLAT PANEL. DO NOT LAY THE FLAT PANEL ON
THE FLOOR WITHOUT ANY PROTECTION TO THE GLASS. THE FLAT PANEL IS
HEAVY AND FRAGILE. AT LEAST (2) QUALIFIED PERSONNEL ARE STRONGLY
RECOMMENDED FOR INSTALLATION OF THIS PRODUCT. FAILURE TO DO SO
COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE TO THE FLAT
PANEL.
Figure 1
Figure 2
1. Once the flat panel is inverted, use a
measuring tape to find the center of
your flat panel measuring from
outside to outside of the chassis
(Figure 1).
2. Using a pencil lightly mark the
center of your flat panel
(Figure 2).
CL
L C
Tape
Measure
Marking the
Center of the
Display
Display
Bottom
Inverted
Display
Display
Top
Inverted
Display
Mounting Bracket Positioning
Arrows Facing
Out
Display Bottom
Right
Mounting
Bracket
Left
Mounting
Bracket
3. Lay the left and right mounting brackets
over the mounting points, with the stamped
arrows facing out (Figure 3).
Figure 3