Philips 32PFL3514D - Manual (Page 26)

25
English
2
Press a number (1 to 135) to enter the number of the channel you
want to add, then press OK.
10
For analog channels,
select a channel to be
added using number keys.
For digital channels,
you must perform
Autoprogram function.
Add channels
Ch Change Back
BACK
PICTURE
SOUND
FEATURES
LANGUAGE
USB
SETUP
3
Press MENU to exit.
Note
• If setup completes successfully, [Added to the channel list] is displayed.
• If external input is used, it is not possible to register the channel and [Unavailable] will be
displayed on the TV screen.
• By pressing or , you can select the memorized channels only.
Optimize the Signal Quality from Your
Antenna
You can optimize your signal quality by tuning in ATSC channels with
weak signals, and adjusting the antenna.
1
Press MENU on the remote control and select [SETUP] >
[Antenna].
2
Press OK to confi rm your choice.
3
Press a number (1 to 135) or press CH+ or CH- to select the
channel for which you want to check the digital signal strength.
4
Press MENU to exit.
2
Press or to select the channel you want to remove, then press OK.
Ch Select Watch/Skip Back
BACK
OK
Highlight channels for Ch Up/Down key
selection.
40.2
40.3
DTV
DTV
PICTURE
SOUND
FEATURES
LANGUAGE
USB
SETUP
DTV 40.1
• The channel display for the removed channel darkens. You will
not be able to select the channel again using CH +/-.
• To reactivate a removed channel, press or and press OK.
The registered channels are highlighted.
• When you remove a major channel, its minor channels are
removed as well.
Note
• The channel with the [DTV] indicated on the display is ATSC. Otherwise the channel is NTSC.
3
Press MENU to exit.
Add Channels
This function lets you add the channels that were not added by the
autoprogram due to the receptible condition at the initial setup.
1
Press MENU on the remote control and [SETUP] >
[Add Channels].
Channel List
Antenna
Autoprogram PICTURE
SOUND
FEATURES
LANGUAGE
USB
SETUP Add Channels
EN