PYLE Audio PLTVD7IN - Manual (Page 12)

10
INTRODUCTION
Preparing & Using The Remote Control
4. BATTERY
BATTERY INSTALLATION
NOTICE (BATTERY)
PLEASE FOLLOW THE INSTRUCTIONS
BELOW. INCORRECT BATTERY USEAGE
MIGHT CAUSE EARLY DISCHARGE, LEAKAGE
OR CORROSION DAMAGE.
* Do not insert battery in the wrong direction.
Be sure to observe the correct polarity (+/-) as
indicated in the battery compartment.
* It is dangerous to charge/heat/open or short
circuitry the battery.
* Please remove the battery in case of not
using the remote control for a long period of
time.
* It is time to replace the battery if the remote
control does not work properly or if the
operating range becomes reduced.
* Should battery leakage occur, clean the
battery compartment with a soft cloth and
replace with a new battery.
USING THE REMOTE CONTROL
NOTICE (REMOTE CONTROL)
* The remote control should be aimed directly
towards the remote sensor of the Unit.
* Avoid dropping the remote control.
* Avoid spilling liquids on the remote control or
exposing it to extreme heat.
The remote control should be pointed at
the remote sensor in order for the Unit
Monitor to function correctly.
Distance: Maximum of 16 feet from the
front of the remote sensor.
Angle: Approximately
30 from center.
Please do not locate the Unit where direct
sunlight or fluorescent illumination might
shine directly at the remote sensor. This
will interfere with proper remote control
operation.