Philips VR499/75 - Manual (Page 6)

— 7 —
G
ETTING
C
ONNECTED
U
P
VCR to TV Connection
Connection
Diagram
1 Disconnect the AC power cord of the TV from the AC outlet
and the antenna or Cable from the TV.
2 Connect the antenna or Cable to the VCR.
3 Connect the VCR to the TV using the RF coaxial cable.
4 Plug the AC power cords of the VCR and TV into the AC
outlets.
To watch a picture from this VCR on the TV:
For customers in Australia;
– select UHF 36 channel(583.25MHz) (video channel of this VCR
when shipped from the factory). If you want to change video
channel, see “Setting the Video Channel” (✈P.8).
For customers in New Zealand;
– be sure to set video channel (✈P.8).
VCR to AV TV Connection
With this connection, you can get better pictures and sounds when playing back a tape.
To watch a picture from this VCR on the
TV, select the video input on the TV, to
which this VCR is connected.
CAUTION
Do not plug the AC power cords until all
connections are completed.
AUDIO
VIDEO
RF OUT
ANT.IN
IN OUT VHF
UHF
Outdoor antenna Indoor antenna
Back of VCR
RF coaxial cable
(supplied)
Back of TV
ANT. IN
RF OUT
Cable
AUDIO
VIDEO
RF OUT
ANT.IN
IN OUT
Back of VCR
Back of TV
To VIDEO/ AUDIO
OUT jacks
Video cable
To video and audio
input jacks
Audio cable
VR299/499-75 EN 7/6/99, 3:46 PM 7