Panasonic ES7109 - Manual (Page 9)

9
English
1 1 1 Cleaning with the self-cleaning recharger (continued) 1
1 Follow the steps outlined below if the status lamp blinks or glows
during the “Clean/Dry/Charge” course or the “Clean/Dry” course.
Blinks Glows
Correctly set the
detergent cartridge and
then restart a course. Remove the shaver from the self-
cleaning recharger and then
check that the [clean] lamp has
gone out. (Be careful as the blade
may be hot or wet.) Check that
the water tank is correctly
attached, the water tank cap is
securely closed and the self-
cleaning recharger is placed
horizontally.
If the status lamp goes
out
Continue a course.
When an abnormality has
been corrected When no abnormality was
found
Press and hold [select] for
approximately seconds to
turn off the status lamp and
then restart a course. It is time to replace the
detergent cartridge and
cleaning liquid inside the water
tank.
Drain the old cleaning liquid
inside the water tank and then
refill it with water. Replace the
old detergent cartridge and
then restart the course.
When the status lamp
goes out When the status lamp glows
again
Continue a course. Contact an authorized service
center.
Cleaning the shaver without the self-cleaning
recharger
1. Disconnect the power cord
from the shaver.
. Apply some hand soap to the
outer foil.
3. Turn the shaver on and then
pour some water over the
outer foil.
4. Turn the shaver off after 10-0
seconds.
5. Remove the foil frame and
clean it with running water.
6. Wipe off any drops of water
with a dry cloth.
7. Remove the system outer foil
and the foil frame to allow
them to dry completely.
ES7109_USA.indb 9 2007/07/12 12:56:27