Philips SCD588/54 - Manual (Page 14)

EN
Other features
15
Connecting / disconnecting belt clip and
neck strap
If the parent unit is operated using batteries, you can carry it in
and around your house, allowing you freedom of movement
while still monitoring your baby.
Connect
• Insert the little spindle on the rear of the belt clip into the
recess (B-10) on the rear of the parent unit.Twist the belt
clip to the left until it clicks in position.
Disconnect
• Twist the belt clip to the right (TURN B) and take it off.
Connecting the neck strap
• Insert the little spindle at the end of the neck strap into the
recess (B-10) on the rear of the parent unit.
Twist the spindle to the left until it clicks in position.
Disconnecting the neck strap
• Twist the spindle to the right (TURN B) and remove it.
Paging parent unit
When the parent unit is misplaced and the volume is switched
off, you can use the PAGE button (A-6) on the baby unit to
locate the parent unit.
1 Briefly press the PAGE button (A-6) on the baby unit.
> A paging alert will sound on the parent unit.
2 To stop the paging alert, briefly press the page button (A-6)
again or any button on the parent unit.
Note: If you press the PAGE button (A-6) too long, the paging
alert will not sound.