Pioneer DJM-400 - Manual (Page 12)

12
EFFECT FUNCTIONS (IN-LOOP SAMPLER/EFFECT PARAMETERS)
5. At the point you wish to sample record, press one of the
non-lighted BEAT/BANK buttons.
¶ Lighted BEAT/BANK buttons have already been recorded, and
cannot be used again unless their recorded contents are
erased.
¶ Recording begins automatically when the sound signal from
CD player or other component is detected. During recording,
the BEAT/BANK button will flash quickly. During recording
standby, the button will flash slowly at intervals.
¶ When 4 beats of sound at the measured BPM have been
recorded, the BEAT/BANK button flashes slowly and loop play
is performed.
6. If the beat becomes unsynchronized, press one of the
BEAT/PITCH buttons (–, +) to resynchronize the timing of
the playback sample to the currently playing track.
¶ The playback speed increases while the [+] button is
depressed, and decreases while the [–] button is depressed.
7. Rotate the LEVEL/DEPTH dial to adjust the sound balance
between source and sample.
8. To stop loop playback, press the corresponding BEAT/
BANK button.
¶ The BEAT/BANK button indicator will change from slow
flashing to steadily lighted.
[To Playback a Recorded Sample]
1 Set the effect selector switch to [IN-LOOP SAMPLER].
2 Use the effect channel selector to choose the channel for
loop playback.
3 Set the ON/OFF button to ON.
4 Press the BEAT/BANK button containing the sample you
wish to play as a loop.
¶ The BEAT/BANK buttons with recorded samples are lighted.
¶ The selected button will flash slowly and loop play will begin.
5 If the beat becomes unsynchronized, press one of the
BEAT/PITCH buttons (–, +) to resynchronize the timing of
the playback sample to the currently playing track.
¶ The playback speed increases while the [+] button is
depressed, and decreases while the [–] button is depressed.
6 Rotate the LEVEL/DEPTH dial to adjust the sound balance
between source and sample.
7 To stop loop playback, press the corresponding BEAT/
BANK button.
¶ The BEAT/BANK button indicator will light steadily.
[Erasing a Recorded Sample]
1 Set the effect selector to [IN-LOOP SAMPLER].
2 While holding the ERASE (BEAT/PITCH –) button
depressed, press the BEAT/BANK button containing the
sample you wish to erase.
¶ The BEAT/BANK buttons containing recorded samples are lighted.
¶ The indicator in the selected BEAT/BANK button will go out
and the sample will be erased.
EFFECT PARAMETERS
8. IN-LOOP SAMPLER
This function allows you to store 4-beat sounds in up to 5
banks, then output them repeatedly.
Example
Repeat
Bank 1
Present
track
BPM=125