beautypg.com

ProForm 665 E PFTL56507.0 User Manual

Page 9

background image

9

8. Identify the Right Handrail (90), which has a

large hole in the location shown. Hold the Right
Handrail near the console assembly. Attach the
console ground wire to the Right Handrail with a
#8 x 1/2" Ground Screw (87).

Insert the end of the console wire into the large
hole in the Right Handrail (90) and out of the top
as shown; use needlenose pliers if necessary.
Attach the Right Handrail with two 3/4" Screws
(12).

Make sure that no wires are pinched.

Start both Screws but do not tighten them
yet.

Attach the Left Handrail (88) to the console as-
sembly with two 3/4" Screws (12).

Start both

Screws but do not tighten them yet.

12

12

90

88

87

Console Wire

Ground Wire

Hole

8

Console

Assembly

7. Set the console assembly face down on a soft

surface to avoid scratching the console assem-
bly.

Remove the two 1/2" Screws (1) from the
Crossbar (39), and then remove the Crossbar.
Save the two Screws and the Crossbar for
step 9.

Console

Assembly

1

1

39

7

6. With the help of a second person, hold a Bolt

Spacer (80) inside the lower end of the Left
Upright (74). Insert a 3/8" x 4" Bolt (6) with a
3/8" Star Washer (9) into the Left Upright and
the Bolt Spacer. Repeat this step with a second
Bolt Spacer (80), 3/8" x 4" Bolt (6), and 3/8" Star
Washer (9).

Orient the Left Upright (74) and the Left Upright
Spacer (76) as shown. Hold the Left Upright
Spacer and the Left Upright against the Base
(83). Tighten the two 3/8" x 4" Bolts (6) with your
fingers;

do not fully tighten the Bolts yet.

Press a Base Endcap (77) into the Base (83).

With the help of a second person, tip the tread-
mill so that the Base (83) is flat on the floor.

76

74

6

83

80

80

77

9

6