ProForm 665 E PFTL56507.0 - Manual (Page 10)

10
10. Slide the Left Handrail Spacer (96) and the Right
Handrail Spacer (97) onto the top of the Left
Upright (74) and Right Upright (78).
74
96
78
97
10
9. Set the Crossbar (39) on the console assembly.
Tighten two 1/4" x 3/4" Bolts (5) with two 1/4"
Star Washers (14) into the Crossbar.
Start both
Bolts but do not tighten them yet.
Tighten four 1/2" Screws (1) into the Crossbar
(39).
Start all four Screws before tightening
any of them.
Tighten the two 1/4" x 3/4" Bolts (5) and the four
3/4" Screws (12) in the Right and Left Handrails
(90, 88).
5
14
1
39
12
Console
Assembly
5
14
88
90
1
12
9
11. Have a second person hold the console assem-
bly near the Right Upright (78) and Left Upright
(not shown). Connect the Upright Wire (38) to
the console wire.
See the inset drawing. The
connectors should slide together easily and
snap into place. If they do not, turn one con-
nector and try again.
IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN YOU
TURN ON THE POWER. Remove the wire tie
from the Upright Wire. Insert the connectors and
the excess wire into the Right Handrail (90).
Set the console assembly on the Right Handrail
Spacer (97) and Left Handrail Spacer (not
shown).
Be careful not to pinch the wires.
78
Console
Assembly
11
38
Console
Wire
Console
Wire
Wire Tie
38
97
90