Printek Mobile Thermal MtP300 Series - Manual (Page 10)

Getting Started
Installing Media
Each printer comes supplied with a roll of receipt paper. For your convenience, the printers feature a paper
supply indicator as shown in Figure 2. The indicator changes from all green to all red as the paper supply is
used.
Note: For maximum performance and optimum print quality, use only genuine Printek media in your
MtP300 Series printer.
To install media, you must release the paper door by moving the Paper Door Release in the direction shown in
Figure 2 and then lift the paper door to expose the paper compartment.
Figure 2 - Opening Paper Door
Refer to Figure 3 and locate the movable media support. Move the support in the direction shown and then
locate the media between the supports and release the movable support.
Note: Make sure that the roll spins freely on the media supports.
Movable Support
Paper Supply
Indicator
Paper Door Release
Figure 3 - Media Support
4