POSIFLEX Business Machines PP7700 Series - Manual (Page 40)

5 - 4
sure that your software will take care of enough paper feed for the
paper jam prevention issue.
For switch position 8, when it is set to ON in the field, the
printer maybe subject to unpredictable damages and must be
strictly prevented.
The factory default for each position is listed below:
Switch Position 1 2 3 4 5 6 7 8
Wireless interface
w/ auto cutter
ON ON OFF OFF OFF OFF OFF OFF
C. INTERNAL SWITCH
There is an extra internal 4 position DIP switch in PP7700
for more technical settings. To access these setup, please first turn
off the printer power and disconnect every cable from the printer.
Remove 4 screws from bottom of printer and remove the plastic
bottom cover with the power switch pressed. The 4 position DIP
switch seats beside the 8 position DIP switch for setup window
with the switch position counting starts from the nearest side to
the 8 position DIP switch.
This 4 position DIP switch works as following:
Switch position Setting Effect
ê
Function ON OFF
1 Factory internal setting Default Special mode
2 Paper width 58 mm 80 mm
3 Line format 576 dots / line 512 dots / line
4 Reserved N. A. N. A.
The Switch position 1 default set to ON. The OFF status
must be applied in some special application only. The print speed
is fixed at 42.5 lines/sec.
Switch position 2 is usually set to OFF for use with 80 mm
paper width. When the printer is installed with the 58 mm paper