Operating this unit – Pioneer DEH-P7000BT User Manual

Page 30

Select PAIRE FROM PHONE and then

press MULTI-CONTROL to ready for pairing.
READY will be displayed.

Use your cellular phone to establish

connection.
PIN code is set to

0000 as the default. You can

change this code in the initial setting. Refer to
Entering PIN code for Bluetooth wireless con-
nection on page 48.
While connecting,

CONNECTING is displayed.

If the connection is established,

COMPLETED

is displayed.
After connected, this unit automatically
changes to

PH. BOOK DL (phone book down-

load confirmation) display.

# If the connection fails, ERROR is displayed. In
this case, check the cellular phone and try again.
# If three cellular phones have already been
paired, the pairing assignment selection display
will appear. Select one assignment to pair the
new phone. The newly paired phone overwrites
the previously paired phone. The assignment se-
lection operation is the same as Step 3 to 4 of
Pairing a connected cellular phone on the next
page except for the operation below.

! Switching the BD address and device name

Use MULTI-CONTROL to decide to

download the phone book from your cellu-
lar phone or not.
Push

MULTI-CONTROL left or right to select

NO (No) or YES (Yes).
Press

MULTI-CONTROL to decide.

When you select

YES, this unit changes to

PH BOOK DOWNLOAD and the download op-
eration automatically begins. After complet-
ing,

DATA DOWNLOADED is displayed.

According to the circumstances, this unit
changes to

PH BOOK TRANSFER. In this case,

refer to step 4 on Transferring entries to the
phone book on page 39.

# When you select NO, the display reverts to
normal.

Using this unit to initiate a connection

Display the connection menu.

Refer to Introduction of connection and regis-
tration on the previous page.

Use MULTI-CONTROL to select

BT HANDS FREE.

Use MULTI-CONTROL to select a group.

Push

MULTI-CONTROL up or down to select a

group.
NOKIA (Nokia)

—STANDARD (standard)

# Normally select STANDARD. If the device of
Nokia is not paired to this unit, select

NOKIA.

# Push MULTI-CONTROL left or right to display
a group name or an ID.

Press MULTI-CONTROL to switch to

PAIRE FROM PHONE.
Push

MULTI-CONTROL up or down to switch

PAIRE FROM PHONE and SEARCH DEVICE.

Select SEARCH DEVICE and then press

MULTI-CONTROL to start searching.
While searching,

SEARCHING is displayed.

# If this unit fails to find any available cellular
phones,

NOT FOUND is displayed.

Use MULTI-CONTROL to select a device.

Push

MULTI-CONTROL up or down to select a

device name you want to connect.
Press

MULTI-CONTROL to select a device

name.

# Push MULTI-CONTROL left or right to switch
the BD address and device name.