Philips HTS3520 - Manual (Page 13)

13
English
2
Connect a USB storage device to the home
theater.
3
When audio is played, press CREATE MP3.
4
Select [Yes] and press OK to confirm.
5
Select the settings in the [OPTIONS] panel,
then press OK.
• [Speed] : Selects the write-to-file
speed.
• [Bitrate] : Selects the conversion
quality.
• [CRT ID3] : Copies information on the
tracks in the MP3 files.
• [Device] : Selects the USB device
which you use to store the MP3 files.
6
Press to access the [TRACK] panel.
7
Select an audio track, then press OK.
• [Select All] : Selects all tracks.
• [Deselect all] : De-selects all tracks.
8
Select [Start] in the menu to convert, then
press OK.
» A new folder is created in the USB
storage device to store all the new MP3
audio files.
• To exit the menu, select [Exit] and
press OK.
Note
• During the conversion process, do not press
any buttons.
• DTS CDs and copy-protected CDs cannot be
converted.
• Write-protected or password-protected USB
storage device cannot be used to store MP3
files.
CREATE MP3
OPTIONS TRACK
Bitrate 128kbps
SUMMARY
Select Track 0
Start Exit Select All Deselect All
Time 00:00
Track01 04:14
Track02 04:17
Track03 03:58
Track04 04:51
Track05 03:53
Track06 04:09
Track07 04:38
Speed Normal
CRT ID3 Yes
Device USB1
Button Action
/ Selects a preset radio station.
/ Searches for a radio station.
Fine tunes a radio frequency.
Press and hold to erase the
preset radio station.
Press to stop the installation of
radio stations.
PROGRAM Manual: Press once to access
program mode, and press again
to store the radio station.
Automatic: Press and hold for
five seconds to reinstall radio
stations.
Note
• AM and digital radio are not supported.
• If no stereo signal is detected, you are
prompted to install the radio stations again.
• For the best reception, place the antenna away
from the TV or other sources of radiation.
Change tuning grid
In some countries, you can switch the FM tuning
grid between 50 kHz and 100 kHz. Changing
tuning grid erases all preset radio stations.
1
Press RADIO.
2
Press .
3
Press and hold until ‘GRID 9’ (50 kHz)
or ‘GRID 10’ (100 kHz) is displayed.
Play audio from TV or other
devices
Press AUDIO SOURCE repeatedly to select
the audio output of the connected device (see
‘Connect audio from TV or other devices’ on
page 9).
Create MP3 audio files
Use the home theater to convert audio CDs into
MP3 audio files.
1
Insert an audio CD (CDDA/HDCD) into
the home theater.
EN