beautypg.com

Poulan C342B User Manual

Page 8

background image

8

02092

020

86

SUPPORT POST (See Fig. 3)
Use Hardware - - GROUP "B"

1. Rotate cover assembly onto its side as shown.
2. Assemble support post to container support with

the three (3) carriage bolts and locknuts. Tighten
securely.

ALIGNMENT
MARKS

COVER SEAL

FIG. 2

COVER SEAL (See Fig. 2)
No hardware required

1. Align mark on seal with mark at cover opening.
2. Work seal into opening so cover sits between fl anges

of seal.

2

3

LOCKNUTS

CARRIAGE
BOLTS

SUPPORT
POST

FIG. 3

MOUNTING TO TRACTOR (See Fig. 4)
Use Hardware - - GROUP "C & D"

NOTE: For ease of assembly, you may wish to obtain the
as sis tance of another person for mounting assembly to
tractor.
1. Raise seat on tractor to allow assembly to be

mounted.

2. With cover closed, lift assembly and place support

post inside mounting bracket. Allow assembly to rest
on lanced tabs of mounting bracket.

3. Line up holes in mounting bracket with holes in support

post and insert bracket support pin. Secure with retainer
spring.

4. Unlatch and open cover.
5. Secure cover assembly to support tube using short hex

bolt, long hex bolt, and locknuts as shown. Tighten all
hardware securely.

NOTE: Hardware securing support tube to drawbar must
be tightened at this time.
6. Install the four (4) tubing end caps onto container

support. Tap each end cap onto container support
tubes to seat securely.

4

02090

RETAINER
SPRING

LANCED TABS

COVER ASSEMBLY

FIG. 4

LOCKNUTS

END CAP

SHORT
HEX BOLT

LOCKNUTS

BRACKET
SUPPORT PIN

LONG
HEX BOLT

SHORT
HEX BOLT

LONG
HEX BOLT

SUPPORT TUBE

SUPPORT POST

MOUNTING
BRACKET

This manual is related to the following products: