Panasonic KX-TG1837AL - Manual (Page 38)

Multi-unit Operation
38
L
When the handset has been
registered successfully, w will stop
flashing. If keytones are turned on
(page 19), a confirmation tone will be
heard.
Cancelling a handset
A maximum of 6 handsets can be registered
to the base unit. A handset can cancel its
own registration (or the registration of
another handset) that is stored in the base
unit. This will allow the base unit to “forget”
the handset.
1
{j /OK} i “Base Unit Setup” i
{>}
2 Enter “335”.
3 “Cancel Handset” i {>}
L
The numbers of all handsets
registered to the base unit are
displayed.
4 Select the handset(s) you want to
cancel, by pressing the desired handset
number. i {j/OK}
L The selected handset number(s) will
flash.
L
To cancel a selected handset number,
press the number again. The number
will stop flashing.
5 “Yes” i {>} i {ih}
Increasing the range of the base
unit
You can increase the range of the base unit
by using a DECT repeater. Please use only
the Panasonic DECT repeater noted on
page 5. Consult your Panasonic dealer for
details.
Important:
L
Before registering the repeater to this
base unit, you must turn the repeater
mode on.
Setting the repeater mode
1
{j
/OK} i “Base Unit Setup” i
{>}
2 “Other Options” i {>}
3 “Repeater Mode” i {>}
4 “On” or “Off” i {>} i {ih}
Note:
L
After turning repeater mode on or off, w
will flash on the handset momentarily. This
is normal. The handset can be used once
w
stops flashing.
Intercom between
handsets
Intercom calls can be made between
handsets in the same radio cell.
Example: When handset 1 calls handset 2
1 Handset 1:
{
INT} i Press {2} (desired handset
number).
2 Handset 2:
Press {C} / {s} to answer.
3 When finished talking, press {ih}.
Transferring calls
between handsets,
conference calls
Example: When handset 1 transfers a call
to handset 2
Transferring calls between handsets
Outside calls can be transferred between 2
people in the same radio cell.
1 Handset 1:
TG1831-1837AL(e).book Page 38 Friday, February 3, 2006 2:24 PM