PYLE Audio PYM-6 - Manual (Page 6)

4 – PYLE PRO PYM-6 Owner’s Manual
All PYLE PRO products are carefully constructed and tested before shipment.
Units purchased in the USA are warranted to be free of defects in material
and workmanship for two (2) years from the date of purchase. This warranty
is limited to the original retail purchaser of the amplifier.
Should the unit fail due to factory defects in material or workmanship, your
unit will be repaired or replaced at the sole discretion of PYLE.
To obtain warranty service, you must first call our Consumer Return Hotline
at (718) 236-6948 to obtain a Return Authorization Number. This R.A. # must
appear on the outside of your package and on all paperwork relating to your
return.
When returning the unit to us for warranty service, it must be carefully packed
and shipped, prepaid, to:
R.A.#: _____________
PYLE PRO Service Center
1600 63rd Street
Brooklyn, NY 11204
You must also include the following items with your return:
• A copy of your sales receipt or other proof of purchase
• A brief letter, indicating the problem you are experiencing with the
product
• Include in your letter your return address, daytime phone number and
R.A. number
• Also include a check or money order for $15.00 for return shipping,
handling and insurance, or provide your Visa/MC number with
expiration date.
Our obligation under this warranty is limited to the repair or replacement of
the defective unit when it is returned to us prepaid. This warranty will be
considered void if the unit was tampered with, improperly serviced or subject
to misuse, neglect or accidental damage.
Limited Warranty
PYM-6 Specifications
Input Impedance
Mic
Aux
Output Level
Aux Out, RCA & 1/4" Jack
High Imp Out , 1/4" Jack
Low Imp Out, XLR
Sensitivity For Rated Output
Mic
Aux
S/N Ratio
Mic
Aux
Frequency Response
Distortion
Mic
Aux
Feedback Filter
Power Source
Dimensions(HxWxD)
(mm)
Net Weight, LBS(kg)
600 Ohms (Low)
10k Ohms (High)
47k Ohms
3V
120mV
10mV
1.5mV (Low)/10mV (High)
200mV
60dB
70dB
20-20 kHz (+/- 3dB Range)
<0.3%
<0.05%
-12dB
115VAc, 60Hz/230VAc, 50 Hz
2 1/2" x 19" x 7 7/8 "
(64 x 482 x 200)
8.14 LBS(3.7 Kgs)
USING THE FEEDBACK FILTER
After you adjust the mixing controls, test the microphones. If you
hear a loud squeal or other noise, turn FEEDBACK FILTER clockwise
until you eliminate or reduce the feedback.
The FEEDBACK FILTER control decrease feedback by up to 12dB,
If you cannot eliminate the feedback with the FEEDBACK FILTER
control, try connecting a frequency equalizer to help decrease
feedback even more.
Follow the instructions included with the frequency equalizer to
connect it between the PYM-6 and the amplifier.