Pioneer RMF-V4011R - Manual (Page 106)

105
[4] (GET W/B DATA)-White balance adjustment data is output.
Format:Output in the following order.
1STX (02H)
2/ LINEAR WHITE
adjustment data (3 BYTE)
3/CONTRAST adjustment data (3 BYTE)
4/BRIGHTNESS adjustment data (3 BYTE)
5/COLOR adjustment data (3 BYTE) Note 1)
6/TINT adjustment data (3 BYTE) Note 1) and Note 3)
7/BLUE LOW-LIGHT adjustment data (3 BYTE)
8/GREEN LOW-LIGHT adjustment data (3 BYTE)
9/RED LOW-LIGHT adjustment data (3 BYTE)
0/BLUE HIGH-LIGHT adjustment data (3 BYTE)
-/GREEN HIGH-LIGHT adjustment data (3 BYTE)
=/RED HIGH-LIGHT adjustment data (3 BYTE)
~/SHARPNESS adjustment data (3 BYTE) Note 1) and Note 5)
!/ABL LEVEL adjustment data (3 BYTE) Note 2) and Note 4)
@/ABL GAIN adjustment data (3 BYTE) Note 2)
#ETX (03H)
Note 1)Dummy when INPUT=RGB
Note 2)No dependent on mode. (Has one data.)
Note 3)Dummy when PAL signal is input. (INPUT=VIDEO or Y/C)
Note 4)Dummy when COMBINATION=OFF (Data is output when COMBINATION=ON)
Note 5)SHARPNESS data for OFF is output when MULTI=OFF, and SHARPNESS data for ON is output when MULTI=ON.
[5] (GET CONV. USER DATA)=Deflection and convergence data memory area setting state is output.
1STX (02H)
2Memory area selected when INPUT=VIDEO or Y/C & input signal=NTSC.
(3 BYTE)
Example)US 1:Indicates CONV.MEMO-1 is selected.
3Memory area selected when INPUT=VIDEO or Y/C & input signal=PAL
(Or other than NTSC, containing no signals). (3 BYTE)
Example)US 2:Indicates CONV.MEMO-2 is selected.
4Memory area selected when INPUT=RGB & input signal=NTSC. (3 BYTE)
Example)US 1:Indicates CONV.MEMO-1 is selected.
5Memory area selected when INPUT=RGB & input signal=PAL (or other than NTSC, containing no signals).
(3 BYTE)
Example)US 2:Indicates CONV.MEMO-2 is selected.
6ETX (03H)
ADJUSTMENTS