Polycom KH 150 SE - Manual (Page 13)

2
Interface Implementation
This section describes the recommended programming to use the
Wireless Telephone System with an Inter-Tel Axxess or Axxent
System. The procedures assume:
• The Axxess or Axxent system is installed and operational in an
approved configuration. See the Telephone Switch Interface
Matrix document for tested configurations.
• A trained Inter-Tel technician or system administrator will be on
site with the SpectraLink installer to program the system.
• The SpectraLink 6000 System or SpectraLink 8000 Telephony
Gateway is installed and the handsets are available for
programming.
The Inter-Tel Axxess digital interface to the SpectraLink 6000
System is licensed for use in the U.S. and Canada only
Set the Switch Interface Type
SpectraLink 6100 MCU
The SpectraLink 6100 Master Control Unit requires the switch
interface type to be configured using the front panel buttons. The
configuration procedures are detailed in SpectraLink 6100 MCU:
Installation and Operation.
SpectraLink 6300 MCU
When configuring the SpectraLink 6300 MCU, the PBX interfaces are
available as sub-menu selections when defining the Interface Module
type using the SpectraLink 6300 MCU Operator’s Console. Refer to
SpectraLink 6300 MCU: Operator’s Console for details on configuring
the Interface Modules.
PN: 1725-36135-001_D.doc 13