Pioneer DV-566K-s - Manual (Page 14)

Connecting up 02
14
En
Connecting using the
component video output
You can use the component video output
instead of the standard video out jack to
connect this player to your TV (or other equip-
ment). This should give you the best quality
picture from the three types of video output
available.
• Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT jacks to a component video
input on your TV, monitor or AV receiver.
• To set up the player for use with a progres-
sive scan TV, see Component Out on
page 53 .
• Only NTSC video is output when set to
progressive scan.
Taiwanese model only:
Connecting using the D1/D2
video output
If your TV is equipped with a D type video
input, you can use a D video cord to connect
this player to your TV.
• Only NTSC video is output when set to
progressive scan.
• This player is compatible with D1, D2, D3
and D4 input jacks, however, when
connected to a D1 jack, only interlace
video is output.
• If you connect the S-video jack and the D
video connector, and one of the
connected components is not S1/S2
compatible, the automatic aspect ratio
switching will not work with any of the
connected components.
S
L
R
P R
P B Y COAXIAL
OPTICAL
COMPONENT VIDEO OUT VIDEO OUT
DIGITAL
AUDIO OUT AUDIO OUT
TV
COMPONENT
VIDEO IN
S
L
R
P R
P B Y COAXIAL
OPTICAL D1/D2
VIDEO OUT COMPONENT VIDEO OUT VIDEO OUT
DIGITAL
AUDIO OUT AUDIO OUT
TV
D1/D2
VIDEO INPUT
Taiwanese model
DV566.book 14 ページ ２００３年６月１７日 火曜日 午後８時１８分