Parasound Halo T 3 - Manual (Page 17)

OPERATING YOUR T 3 continued
14
Manual Tuning at the Front Panel
Turn on the T 3 by pressing the On-Off button on the front panel or the On button on
its remote control. The station you had previously selected will appear in the display.
Press the < Select > button until < MANUAL > appears in the display.
Turn the round knob clockwise to tune up.
Turn the knob counter-clockwise to tune down.
YOU SHOULD KNOW
In North America, FM stations are separated by at least 100 kHz. When the Region switch is set
to US, the T 3 manual tuning is in 100 kHz steps. In the European Union, FM stations are
separated by at least 50 kHz. When the
Region switch is set to EU, the T 3 manual tuning is in
50 kHz steps. In North America, AM stations are separated by at least 10 kHz. When the Region
switch is set to US, the T 3 manual tuning is in 10 kHz steps. In the European Union, AM stations
are separated by at least 9 kHz. When the
Region switch is set to EU, the T 3 manual tuning is in
9 kHz steps.
Selecting Stations by Entering Frequency
This lets you find stations by selecting their broadcast frequencies. This is done with the
remote control.
Press the Enter Frequency button on the remote control.
After you press the Enter Frequency Button, the frequency display goes blank.
Enter the frequency of the station you want to select with the buttons P 1 - P 9 and 0
on the remote control.
For FM stations below 100 MHz, enter 3 digits in order.
Example: for 95.5 MHz press P 9, P 5, P 5
For FM stations above 100 MHz, enter 4 digits.
Example: for 105.3 MHz press P 1, 0, P 5, P 3
For AM stations below 1000 kHz, enter 3 digits.
Example: for 930 kHz press P 9, P 3, 0
For AM stations above 1000 kHz, enter 4 digits.
Example: for 1040 kHz press P 1, 0, P 4, 0
YOU SHOULD KNOW
When the unit is set for EU operation, you need to enter an extra digit for FM stations because
tuning is in increments of 50kHz. Example: for 104.75 MHz press
P 1, 0, P 4, P 7, and P 5.
1
2
3
4
1
2
3
4
5
6
7
8
9
10
11
See page 18 for T 3 Front Panel and Remote Control layout