Porter-Cable DVDR630VR - Manual (Page 28)

28
Before Operation (Continued)
VCR Record System
Your video recorder uses dual colour standards, PAL
and MESECAM. During recording your video recorder
should select the colour system automatically, however
if you experience problems you may need to do it man-
ually.
DV Record Audio
You need to set this if you have a camcorder using
32kHz/12-bit sound connected to the front panel DV IN
jack.
Some digital camcorders have two stereo tracks for
audio. One is recorded at the time of shooting; the other
is for overdubbing after shooting.
On the Audio 1 setting, the sound that was recorded
while shooting is used.
On the Audio 2 setting, the overdubbed sound is used.
Auto Chapter
When recording, chapter markers are put in specified
setting. You can change this interval to 5 minutes, or
10 minutes. If you select None, switch off automatic
chapter marking altogether with the No Separation set-
ting.
DISC
Disc Initialize
If you load a completely blank disc, the recorder will ini-
tialize the disc.
DVD+R: The Initialize menu will appears. Select “Yes”
then press ENTER.
DVD+RW: The recorder initialize the disc to DVD+RW
mode.
Also, you can format the disc from the Setup menu as
below.
11 Press SYSTEM MENU.
The Setup menu appears.
2 2 Use v / V to select the DISC option.
3 3 While the DISC option is selected, press B to
move to the second level.
4 4 Use v / V to select the Disc Initialize option.
5 5 Press B to move to the third level.
Start icon is highlighted.
6 6 Press ENTER.
Disc Initialize menu appears.
77 Use b / B to select “OK” then press ENTER.
It takes a few moments to format the disc.
Caution
If you want to change the disc format, everything
recorded on the disc will be erased.
Auto
PAL
MESECAM
Disc Record Mode
VCR Record Mode
DV Record Audio
Auto Chapter
VCR Record System
Disc Record Mode
VCR Record Mode
VCR Record System
DV Record Audio
Auto Chapter
Audio 1
Audio 2
Disc Record Mode
VCR Record Mode
DV Record Audio
Auto Chapter
VCR Record System
None
5 Min
10 Min
Start Disc Initialize
Disc Finalize
Disc Label
Disc Protect
PBC
AutoPlay
OK
All data on the disc will be deleted.
Proceed?
Disc Initialize
Cancel