Before using the system – PYLE Audio PLCD20CH User Manual
Page 17
17
BEFORE USING THE SYSTEM
SETTING UP FOR OPERATION
Be sure to press reset button when all wiring is completed. Load the discs into the
CD magazine and install the magazine into the CD changer.
Wiring — Using FM Modulator
This system is designed to convert CD sound into FM signals (89.1 MHz or 88.7
MHz) and play them on the existing FM car stereo. Carry out the steps outlined
below before using the system.
Turn on the car stereo and select FM band operation. Tune the radio to either 89.1
or 88.7 MHz (depending on frequency to which the installer has set the unit) or push
the pre-set memory button that has been set as per the above description.
Power ON and Play
Turn on the changer by pressing the OFF button on the remote controller.
The LCD panel on the display unit will illuminate and play of first disc will begin.
Adjust volume, balance and tone to your taste by using the controls on the car stereo.