Philips SRU 5120/86 - Manual (Page 6)

Check if you can operate all functions on your TV with the SRU 5120.
• If a key does not function properly, keep it pressed until it works.
Then release the key immediately.
Repeat this for every key that does not work.
• If the TV responds to all of the key commands, the SRU 5120 is
ready for use. Do not forget to note your code.
Keep the TV key pressed for 5 seconds to exit setup mode.
• When no key is pressed for 2 minutes or more the remote control will
exit setup mode automatically.
When setting the remote control for other devices, be sure to enter
and exit setup mode with the appropriate mode key. DVD for DVD
player/ recorder and VCR.
Full search setup
If your code does not work or if the brand of your device is not
mentioned in the code list, you can try setting the remote control with
full search setup.
Press the mode key of the device you wish to set up the remote
control for. E.g. the TV key.
Press the key until it flashes twice and then remains lit.
Press and hold the Stand-by key of the SRU 5120 until your TV
switches off (stand-by).
Then release the key immediately.
• The SRU 5120 is now set to operate your TV.
Full search setup takes about 5 minutes.
10
10
2
9
9
1
8 7
6
Installing the remote control
ENGLISH
6