Operation modes – Panasonic 35 User Manual
Page 33
Operation modes
23
*1)
It is not possible to select a particular channel unless it has an LED head connected to it.
*2)
Conditions under which the signals below are set to ON.
- READY ALL: ON when CHs are selected on the front panel of the controller, and all selected channels
are ready
*3)
for irradiation.
- READY1-4: ON when the corresponding CH is ready for irradiation. Note that even if the CH is not
selected on the front of the controller, if the channel is ready
*3)
for irradiation, the signal will be ON.
- BUSY1-4: ON while irradiation is in progress on the corresponding channel.
*3)
Irradiation-ready state
- The INTERLOCK input on the rear of the controller is set to ON.
- Irradiation conditions (intensity and time) have been set, and the 1STEP time value is not set to 0.