beautypg.com

Connecting speakers to the a 23 – Parasound A 23 User Manual

Page 8

background image

YOU SHOULD KNOW

Correct Speaker Polarity is Important
Polarity refers to + and – connections. Speaker wires are coded with printing or a ridge on the
insulation on one of the leads so you know which lead was connected to the + and – terminals
at the other end. This coding will help you keep the + and - polarity consistent for both channels.

Speaker Wire Length and Gauge (thickness)
When selecting speaker wire, follow these guidelines:
• Keep the length of your speaker wire as short as possible
• Use the thickest wire practical. For lengths greater than 50 feet, use speaker wire with an AWG

(gauge) of 14 or lower. The smaller the AWG, the thicker the wire.

• Do not use speaker wire that is thinner than 16 AWG.
• Keep wire lengths for both channels as close to equal as possible.

Speaker Terminals

The five-way binding post speaker terminals on the A 23 accept most speaker wire
terminations including single or dual banana plugs, 1/4” spade lugs, or bare wire.
Refer to Bare Wire Speaker Termination in the

Technically Speaking

section for

information about bare wire termination.

What You’ll Need:

• Two lengths of speaker wire

AWG 16 or thicker with banana
plugs, spade lugs, or bare wire

• Loudspeakers or a speaker

selector box

Before Connecting

Remove power to all the components in your audio system.

To Connect

Insert one wire with the ridge or other marking into the red

Right +

(positive) speaker

terminal on the A 23. Insert the wire without the ridge or other marking into the black

Right

-

(negative) speaker terminal on the A 23.

Insert the other end of the wire with the ridge or other marking into the red right +
(positive) terminal on the speaker. Insert the wire without the ridge or other marking
into the black right

-

(negative) terminal on the speaker.

Repeat steps 1 and 2 for the left channel

CONNECTING SPEAKERS TO THE A 23

5

1

2

Stripped
AWG wire

Dual

Banana Plug

Common Speaker Connectors

Single

Banana Plug

Spade Lug

Red ususally
designates right

The GND notch
signifies ground
or speaker left

3

&

4

3

2

4

C A U T I O N

1

Speakers