Precor M9.2s - Manual (Page 19)

page 13
Changing the Display to U.S. Standard or Metric
The M9.1 or M9.2s treadmill can display speed in either miles per hour (mph) or kilometers per
hour (kph). When the treadmill is shipped from the factory, it is set to display in U.S. Standard
units of measure. You can easily change these settings by taking the following steps:
Note: The treadmill will retain your selection even when it is turned OFF and unplugged. You can
change your selection at any time, simply by repeating the following steps.
1. Place the magnetic safety key in the ACTIVATE position on the electronic console. Walk to the
front of the treadmill and turn the power switch ON. (The magnetic safety key must be placed
in the ACTIVATE position before you can turn ON the treadmill.)
2. Straddle the running belt with your feet firmly planted on the right and left side platforms.
(Stand close enough to the electronic console, so that you can extend your arm and touch the
keypad.) Use the clip on the magnetic safety key and attach it to your clothing at your
waistline.
3. At the “ENTER WEIGHT” prompt, simultaneously press and hold the SPEED key and the
SCAN key. The prompt, “PRESS FOR MPH & MILES MODE OR FOR KPH & KILOME-
TERS MODE” appears on the display. Release both keys.
4. Use the appropriate SPEED or key to indicate your selection.
You can continue your workout by following the appropriate steps found in Quick Steps to
Working Out or turn OFF the treadmill by moving the magnetic safety key to the OFF position.
Selecting the Time or Distance Prompt on the M9.2s
When using a M9.2s preprogrammed course, you can measure your workout by distance or time.
You see the “SELECT DISTANCE” or “SELECT TIME” prompt after you enter a course selection. The
default measurement is distance.
To change the prompt, follow the steps above in Changing the Display to U.S. Standard or Metric.
1. After step 4 above, two messages scroll across the display: one confirms your mph or kph
selection and the other states, “PUSH FOR DISTANCE FOR TIME OR ‘STOP’ FOR ASK.”
Press the appropriate key after answering one of the following if/then scenarios:
If you want,... Then,...
your workout measured by distance press the key
your workout measured by time press the key
the option of selecting time or
distance prior to each workout press STOP
After you press an arrow key, a message scrolls across the display
confirming your selection.
2. Continue with your workout or turn OFF the treadmill by removing the magnetic safety key
from the ACTIVATE position on the electronic console. If you turn OFF the treadmill, be sure to
store the safety key in a safe place to prevent unauthorized use.