Precor M9.2s - Manual (Page 15)

page 9
Note: After extensive use, vibrations from the treadmill may cause the clamp to loosen.
You may need to periodically inspect the screws and, if necessary, tighten the handrail
clamp screws using the hex key (G) provided.
e. Proceed to the other side of the treadmill and follow steps a through d to complete the
installation of the lower handrails.
24. Return to the upper handrail clamp, look underneath the clamp to be sure that the handrail
ends meet in the middle of the clamp, readjust the handrails if necessary, and tighten the
screws securely using the hex key (F) provided.
25. If you need to move the treadmill, ask for additional assistance. Check to be sure the treadmill
is turned OFF and the power cord is unplugged from the power outlet. Roll the treadmill on its
front wheels to the new location by lifting the rear end of the unit.
26. Plug the treadmill into a standard 120v household outlet. Make sure that no other appliances
use the same circuit as the treadmill.
27. Continue on to Checking the Alignment of the Running Belt on the following page to complete
the installation of the treadmill.
Checking the Alignment of the Running Belt
The belt is aligned at the factory before shipment. However, during shipment or by using the
treadmill on an uneven surface, the belt might move off center. Proper belt alignment is important
because it allows the belt to remain centered and assures smooth operation. Follow these steps to
check the alignment:
1. On the electronic console, move the magnetic safety key to the ACTIVATE position. Locate the
ON/OFF switch at the front of the treadmill and turn ON the treadmill.
2. Stand beside the treadmill and answer the standard start-up questions as instructed below:
a. At the “ENTER WEIGHT” prompt, specify a weight and press the SCAN/ENTER key.
b. At the “SELECT COURSE” prompt, use the arrow keys to select “MANL” (Manual) mode
and press SCAN/ENTER.
3. Continue standing next to the treadmill and bring the running belt up to a speed of 2 miles per
hour by pressing the SPEED key.
4. Walk to the back of the treadmill and observe the belt as it moves (watch for a couple of
minutes).
If the running belt,… Then,...
tracks within the green portion the belt is functioning correctly
of the label and no adjustment is necessary.
runs or drifts into the red portion you need to adjust the belt;
of the label see Aligning the Running Belt in
Chapter 6.
Important: If you notice that the belt needs alignment, make the adjustments at once. Failure
to do so might cause the belt to tear or fray which is not covered by the Precor limited
warranty.
5. Press STOP or SPEED until the running belt stops.
If the belt is functioning correctly, the treadmill is ready to use.
CAUTION: Do not walk on the running belt
during this procedure.
CAUTION: If you hear or notice any chafing or
the running belt appears to be getting
damaged, stop the running belt immediately
by pressing the STOP key. Contact a Precor
Service Representative.
CAUTION: Do not remove the 3-prong plug or
otherwise bypass it with an adapter in order
to use a non-grounded outlet.