Pioneer VSX-D509S - Manual (Page 52)

52
Additional Information
Symptom
Broadcast stations
cannot be selected
automatically.
No sound from
surround or center
speakers.
Sound is produced
from other
components, but not
from LD or DVD
player.
No sound is output or
a noise is output when
software with DTS is
played back.
When a search is
performed by a DTS
compatible CD player
during playback, noise
is output.
Cannot be remote
controlled.
The display is dark or
off.
Cause
• Weak radio signal.
• Speaker settings are incorrect.
• The rear and/or center levels are
turned down.
• The surround and/or center speakers
are disconnected.
• SIGNAL SELECT is set incorrectly.
• The digital inputs are assigned
incorrectly, or not at all.
• SIGNAL SELECT is set to “ANALOG”.
• A DVD player not compatible with
DTS is used, or the setting of DVD
player is incorrect.
• The digital output level is adjusted on
a CD player or other component
equipped with digital output level
adjustment capability. (The DTS
signal has been altered by the player,
and cannot be read.)
• The search function performed by the
player slightly alters the digital
information, making it unreadable.
• The remote control batteries have
worn out.
• Too far away or bad angle of
operation.
• There is an obstacle between the
receiver and the remote control.
• Strong light such as fluorescent light
is shining onto the unit's remote
control signal light-receiving
window.
• The FL DIMMER button is pushed.
Remedy
• Connect an outdoor antenna (refer to
page 13).
• Refer to “SPEAKERS setting mode”
on page 17 to check the speaker
settings.
• Refer to “Setting the volume level of
each channel” on page 22 to check
the speaker levels.
• Connect the speakers (refer to page
14).
• Set SIGNAL SELECT to “DIGITAL” or
“ANALOG” according to the type of
connections made. (refer to page 37).
• Set the digital input settings correctly
(refer to pages 20-21).
• Make digital connections (refer to
page 11) and set SIGNAL SELECT to
“DIGITAL” (refer to page 37).
• Refer to the instruction manual
supplied with the DVD player.
• Set the digital volume level of the
player to full, or to the neutral
position.
• This is not a malfunction, but be sure
to turn the volume down to prevent
the output of loud noise from your
speakers.
• Replace the batteries (refer to page 7).
• Operate within 23 feet ( 7 m), 30° of
the remote sensor on the front panel
(refer to page 7).
• Remove the obstacle or operate from
another position.
• Avoid exposing the remote sensor on
the front panel to direct light.
• Press FL DIMMER on the remote
control repeatedly to return to the
default.
If the unit does not operate normally due to external effects such as static electricity
Disconnect the power plug from the outlet and insert again to return to normal operating conditions.