Precor Assembly Guide Ab-X100 - Manual (Page 10)

Ab-X100 Assembly Guide
page 10
Main Frame
Base Support
Pivot Arm
Support Bar
Handlebars
2 - 1" shoulder
bolts
2 - pivot
arm caps
6. Lift the Support Bar so you can access the Pivot
Arm mounting holes.
7. Have your assistant angle the Handlebar
Assembly beneath the Support Bar and position
the Pivot Arms so you can insert a shoulder bolt
through each sleeve. Thread the shoulder bolts (H)
into the mounting holes to secure the Pivot Arms.
Wrench tighten.
Note: The Pivot Arms can fall off the Handlebar
Assembly, so keep the assembly as level as
possible.
8. Insert the Pivot Arm Caps (K). Apply pressure to
secure them.
9. Lower the Handlebar Assembly and rest it on the
floor.
10. Retighten the four bracket screws.
Assemble the Main Structure, continued