beautypg.com

Important safety instructions – Polaroid FLM-1911 User Manual

Page 4

background image

EN
G

L

ISH

3

Safety Instructions

To prevent any injuries, the following safety precautions should be observed
in the installation, use, servicing and maintenance of this equipment.
Before operating this equipment, please read this manual completely,
and keep it nearby for future reference.

Do not place the equipment on any uneven or unstable carts,
stands, tables, shelves etc..
The equipment may fall, causing serious injuries to children or adults
and serious damage to the equipment itself.
Use only a cart or stand recommended by the manufacturer.
This equipment and recommended cart or stand should be handled
with care. Quick stops, excessive force, and uneven surfaces may
cause the equipment and recommended cart or stand to overturn.

Never overload wall outlets and extensions.
Use and handle the power cord with care.
Do not place any heavy objects on the AC power cord.
Do not pull the AC power cord. Do not handle the AC power cord
with a wet hand.
Do not touch the power cord and antenna cable during lightning.
Unplug this apparatus during lightning stoms or

when unused for long periods of time.

Do not place, use or handle this equipment near water.

Never expose the equipment to liquid, rain, or moisture.
Seek for service if any of the above is spilled into the equipment.

Do not expose the equipment to extreme temperatures or
to direct sunlight, the equipment may overheat and can be damaged.

Do not install the equipment near any heat sources such as
radiators, heat registers, stoves, or any other apparatus
that might produce heat.

IMPORTANT SAFETY INSTRUCTIONS

Do not disable the 3-wire grounding type plug. The grounding pin
on the 3-prong plug is an important feature. Removing the grounding
pin will increase the risk of damaging the equipment.
If you can not fit the plug into the electrical outlet, contact an
electrician to install a grounding outlet.

Always operate this equipment from the type of power source
indicated on the rear of the serial/model plate.